Renewable Energy

Emulsion buffer layer limits screen-printing degradation in copper-plated HJT cells

Chinese researchers link efficiency losses to worn screen mesh knuckles and find that a 4.7% emulsion coverage offers the best protection-uniformity balance.

Mira KovalenkoNovember 15, 20265 min read0 views
A conceptual close-up shows a screen-printing mesh above a silicon wafer, with an emulsion layer separating the mesh from the wafer surface.

Researchers in China have investigated how screen printing damages copper-plated silicon heterojunction (HJT) solar cells and have developed an emulsion buffer layer intended to reduce the effect. The work focuses on the photoresist-printing step used in copper metallization, where the screen mesh can contact the wafer directly and repeatedly.

In commercial production, the team observed conversion efficiency falling from 26.2% to 25.7% over 15,000 consecutive printing cycles. Open-circuit voltage and fill factor accounted for most of the loss, while short-circuit current density and electrical resistance stayed largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.

Wear at the mesh knuckles

Using three-dimensional confocal microscopy, the researchers identified progressive wear on the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer grew, increasing mechanical stress on the passivation layers beneath. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements indicated higher recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.

The printing step differs from conventional silver-paste screen printing, according to corresponding author Lang Zhou. In silver printing, the screen openings cover only 2–5% of the area and an emulsion layer keeps the mesh from touching the wafer. Full-area photoresist coating typically uses a screen without emulsion coverage so that resist is deposited uniformly across the wafer, meaning the mesh contacts the wafer extensively during every printing cycle.

Emulsion coverage trade-off

To prevent direct contact, the team added an emulsion buffer layer and evaluated six patterns with coverage ratios from 2.9% to 16.6%. The tests revealed a trade-off: greater emulsion coverage reduced mechanical damage but impaired photoresist distribution. A coverage ratio of 4.7% gave the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity.

The researchers attributed the improvement to the emulsion layer separating the mesh from the wafer surface and thereby reducing cumulative mechanical damage to the sensitive passivation layers. Zhou said the results show that a relatively simple change to screen design can substantially mitigate printing-induced degradation and offer a practical route to more reliable manufacturing of copper-plated HJT cells. The findings were published in Solar Energy.

Copper metallization context

The study arrives as the solar industry explores copper as a lower-cost alternative to silver contacts in HJT cells. In April 2026, researchers at China’s Nankai University reported a silver-free HJT cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating, addressing adhesion, contact resistance and stability at the ITO interface. Separately, researchers at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT cell; cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95%. Those results indicate copper’s potential to cut silver use, while further work on processing and electrical performance remains necessary.