High strain rate testing can provide material data that makes computer simulations of impacts and crashes more representative, according to Andrea Incardona, an application engineer and product specialist at Instron, a maker of high strain rate testing machines. In the article, Incardona argues that simulation’s usefulness depends on how accurately a model captures the material, not just how quickly a design can be evaluated.
Many materials have strain-rate-dependent properties, meaning their mechanical response changes as loading speed rises. A material characterized under quasi-static conditions may therefore behave differently in a rapid impact or crash. Incardona cites a 2025 study in SAE International Journal of Materials and Manufacturing, “Influence of Strain Rate Effect on Mechanical and Crashworthiness Properties of CFRP Composite Structures.” The study found that adding strain-rate-dependent properties to crash simulations reduced discrepancies between simulated and experimental results: peak acceleration discrepancy fell by 6.5%, while mean acceleration and displacement discrepancies fell by 5.9% and 6.3%, respectively.
From quasi-static to rapid loading
High strain rate characterization can extend material data beyond conventional quasi-static tests. Depending on the material, specimen geometry and test method, Instron says materials can be characterized from quasi-static conditions up to strain rates approaching 1,000/s. Tests may last only 3 to 10 milliseconds, requiring data acquisition that can capture rapid changes in force and deformation.
If strength, stiffness, deformation mechanisms or failure behavior change as strain rate increases, a model built only on conventional data may not represent rapid events accurately. Comparing the same material at different loading rates can show whether such changes matter for a given simulation, according to the article.
Material selection and development
Conventional strength and stiffness data do not necessarily reveal how a material will respond when loading is rapid. Two materials that look comparable in conventional tests may behave differently under high strain rate conditions. Characterizing their dynamic behavior allows engineers to consider deformation, energy absorption and failure under conditions relevant to the application, the article says.
That information becomes important when performance must be balanced against weight, as in automotive crash structures or aerospace components. Dynamic material data can support both material selection and component design decisions, according to Incardona.
Data capture and validation
Incardona describes a development process in which material behavior is measured, incorporated into simulation, used to compare design options and then validated through physical testing. In that approach, material testing is not only a final check on an existing design; dynamic data can be used earlier to assess suitability and refine a component.
Accurate data capture is critical because high strain rate tests can last only a few milliseconds. Instron says its high strain rate testing systems support data acquisition at up to 200 kHz, while digital image correlation can provide additional information about strain development across the specimen. Analysis tools can then support data processing and theoretical modelling.
The article frames the value of high strain rate testing in terms of relevance: material data is useful only if it reflects the conditions a component will face. By showing how materials respond to rapid loading, such testing can give engineers a more complete picture for simulation, material selection and product development, according to Instron. The article presents the case from the company’s perspective and cites one published study; it does not report independent validation of Instron’s systems.
