Zeph Gage has built a rear-only portal axle for a Jeep XJ that is designed to deliver much of the clearance benefit of a full portal setup at a fraction of the usual price. The conversion combines a Ford 9-inch axle housing, geared hubs from a military Humvee and HMMWV portal adapters from Jesse Haines Fabrication.
Portal axles place a gear reduction at each driven wheel instead of relying only on differential and axle-shaft placement. That lets the axle tubes sit higher, leaving less hardware below the frame. It also creates room for larger tires. A typical aftermarket set costs around $20,000; Gage's rear unit is described as costing about one-fifth of that, or roughly $4,000.
Why the differential is upside down
The Humvee portal hubs use two gears and reverse the direction of the input shaft's rotation. To make that work with the Ford 9-inch, Gage mounted the differential upside down so the driveline turns in the required direction. A Yukon Gear and Axle third member is then attached, creating what amounts to a high-pinion arrangement from low-pinion components.
According to the build description, the arrangement adds about six inches of clearance. It also preserves full shock travel—a detail that can be difficult to maintain in a portal installation—and reduces load on the differential. The article presents the setup as effectively bulletproof, but that is a characterization of the design rather than a verified test result.
Rear-only layout avoids packaging limits
Gage did not convert the front axle. Keeping the original solid front axle avoids the packaging problems that can arise when portal hardware is added to a vehicle that never had it. It also leaves more room for suspension travel and keeps the ride height from becoming excessively tall. The approach is common in radio-controlled rock crawlers, where a rear portal axle can improve clearance without forcing a full front-end redesign.
The conversion is not a bolt-on kit. Gage fabricated brackets, made custom-tapped plates and assembled a two-piece brake rotor with a Ford Fusion caliper. The Fusion caliper was selected partly because it has an integrated electric parking-brake solenoid and because it helps with clearance.
The finished XJ can drive over a five-gallon bucket while retaining several inches of clearance above it, according to the article. That extra height at the rear is meant to keep the back of the vehicle from hanging up on obstacles that the front can steer around. A video from Outdoor Auto covers additional details, including how the front and rear gearing were matched.
